<strike id="rn5jz"></strike>

        解決方案 Solutions


        Supertex公司的 MD1715和TC8020是高清醫療超聲圖像應用芯片組。MD1715是兩路五級高壓高速脈沖發送芯片,采用先進的CMOS技術,±4.5 到12.5V工作電壓,輸出電流2A,1nF負載的上升和下降時間6.5ns,傳輸時延10ns,1.8V-3.3V CMOS邏輯電平,而TC8020由六對高壓低閾值N溝和P溝MOSFET組成,集成了柵極-源極電阻和齊納二極管,50V時的峰值電流+/-3.5A。本文介紹了MD1715和TC8020主要特性。MD1715和TC8020典型應用電路,以及詳細電路圖。

        The Supertex MD1715, paired with the Supertex TC8020, forms a two channel, five level, high voltage, high speed transmit pulser chip set. The chip set is designed for medical ultrasound imaging applications, but can also be used for metal flaw detection, nondestructive evaluation, and piezoelectric transducer drivers.

        The MD1715 is a two channel logic controller circuit with 12 low impedance MOSFET gate drivers. There are two sets of control logic inputs, one each for channels A and B. Each channel consists of three pairs of MOSFET gate drivers. These drivers are designed to match the drive requirements of the Supertex TC8020.

        The TC8020 is the output stage of the pulser, with six pairs of MOSFETs. Each pair consists of a P-channel and an N-channel MOSFET. They are designed to have the same impedance and can provide typical peak currents of ±3.5 amps at 200V.


        Advanced CMOS technology

        ±4.5 to 12.5V power supply voltage

        2A output source and sink current

        6.5ns rise and fall time with 1nF load

        10ns propagation delay

        ±2ns matched delay times

        12 matched channels

        1.8V to 3.3V CMOS logic interface

        Smart logic threshold

        Low inductance package


        Medical ultrasound imaging

        Piezoelectric transducer drivers

        Metal flaw detection

        Nondestructive evaluation

        The Supertex TC8020 consists of six pairs of high voltage, low threshold N- and P-channel MOSFETs in a 56-lead QFN package.

        All MOSFETs have integrated gate-to-source resistors and gateto-source Zener diode clamps which are desired for high voltage pulser applications. The complimentary, high-speed, high voltage, gate-clamped N- and P-channel MOSFET pairs utilize an advanced vertical DMOS structure and Supertex’s well-proven silicon-gate manufacturing process. This combination produces a device with the power handling capabilities of bipolar transistors and with the high input impedance and positive temperature coefficient inherent in MOS devices.

        Characteristic of all MOS structures, this device is free from thermal runaway and thermally-induced secondary breakdown. Supertex’s vertical DMOS FETs are ideally suited to a wide range of switching and amplifying applications where very low threshold voltage, high breakdown voltage, high input impedance, low input and output capacitance, and fast switching speeds are desired.


        High voltage, vertical DMOS technology

        Integrated gate-to-source resistor

        Integrated gate-to-source Zener diode

        Typical peak output +/-3.5A at 50V

        Low threshold, low on-resistance

        Low input & output capacitance

        Fast switching speeds

        Electrically isolated N- and P-MOSFET pairs


        High voltage pulsers



        Piezoelectric transducer drivers

        General purpose line drivers

        Logic level interfaces





        <strike id="rn5jz"></strike>